Worried your beloved Moto 360 is going to pick up scuffs and scratches during use? Perhaps this 3D-printed bumper will do the trick. Made by Raelx and priced at just $8, it wraps around the outer edge of your watch and prevents its shiny stainless steel frame from picking up little nicks when you accidentally knock it against stuff.

We don’t typically buy protection for our watches, but with fragile wearables becoming increasing popular, cases and bumpers like this one are likely to start popping up all over the place. And let’s face it, if you have a watch as pretty as the Moto 360 is, you want to make sure it stays sharp.

Fortunately, it won’t cost a lot to do that, thanks to Raelx, an independent seller who is now offering these nifty bumpers for $8 on Shapeways. There are two options available — the one up top that’s slightly raised around the edges to provide some protection to the Moto 360’s display, and the one below that sits flush with it.

Both are available in a wide variety of pretty colors, and they promise not to interfere with the use of your Moto 360’s button or display in any way. What’s more, your device will still fit in its charging dock even while it’s wearing its bumper.

Order your Moto 360 bumper from Shapeways now via the source link below.

• SourceShapeways
• ViaAndroid Police